Tuesday, April 5, 2016

WIRE MESH HANDLER



Lift And Transport Wire Mesh Panels With Ease


USE WITH A FORKLIFT
The Mesh Handler must be used on level ground with the forks level.

We recommend:
Using 6 or 8 hooks for bundles that are 20 feet long.

For 6-point lifts, we recommend using the 4 outer hooks and a pair of hooks on one of the fork tubes.
Using 4 hooks for bundles that are 10 feet long or shorter.

For 4-point lifts of bundles 10 feet long or shorter, we recommend using the 4 inner hooks on the fork tubes.

The load must be centered under the Mesh Handler. Hooks must always be used in pairs at each tube. Never lift with one end of a tube and not the other end. The lifting chain lengths should be adjusted so that all are tight with proper load-sharing. The chains must be routed through the angle wedges such that the load is applied to the angle wedge and not the shackle attachment point. Lifts should always be smooth -not jerky.

Before lifting, the forklift operator must make sure all personnel are at least 20 ft. away from the mesh.  Should a bundle break loose, the stack has a tendency to spread rapidly which could cause severe injury or even death. Make sure all personnel on the ground are clear of lifting area when lifting.

1155 Wire Mesh Handler - w/Fork Pockets 39" DC -Requires 48" or wider Carriage  -  Handles up to 8 ft. X 20 ft. wire mesh bundles 13' 7000 lbs 1025 lbs.
1155·36CCFP Wire Mesh Handler - w/Fork Pockets 36" DC -Requires 44" or wider Carriage  -  Handles up to 8 ft. X 20 ft. wire mesh bundles 13' 6500 lbs 1025 lbs.
1155-24CCFP Wire Mesh Handler - w/Fork Pockets 24" DC Requires 32" or wider  Carriage  -  Handles up to 8 ft. X 20 ft. wire mesh bundles 13' 6500 lbs 1025 lbs.

No comments:

Post a Comment